Re: GearRat's '52

Posted by Garrett Cuellar On 2012/10/28 16:43:26

Hey Guys!

Thanks for the advice! On further examination, I found that the plate was a little bent where the holes were. I was able to bend the plate close to where it needed to be, than I filed out the holes a tad. Now the clutch and pressure plate are on and centered up.

Tomorrow I will slide the transmission back into place, connect the linkage, and possibly get the drive shaft & speedo cable back in. I'll need to get an early start to have everything installed before Tuesday "the test drive". Oh yeah, and I need to have her registered. It will be tough to get her out on the road "legally" by Halloween, but I will be extremely happy just to have her moving!

-Garrett