Well... I vacuumed out the '52 today, went to remove the back seat bottom cushion and knocked a piece of the body off, LOL. It was where some really bad rust was, and they had used wire mesh and bondo to repair it. I was wanting to make some patch panels and what happened today gave me an excuse to do so. Used a flux welder, and copied the contours under the drivers door on a piece of 26 gauge. I'm looking forward to doing more on the car! At least it didn't make it look worse.
-Garrett
Attach file:
(66.85 KB)
(61.66 KB)
(36.62 KB)
(62.30 KB)
This Post was from: https://packardinfo.com/xoops/html/modules/newbb/viewtopic.php?post_id=118318