Working on the "A" pillar today in 19 degree weather, got to get a heater for the garage. Cut out the rust on the bottom of the "A" pillar sheet metal. There is a block of rubber that holds the bottom shape which mad it really easy to form to. I hand formed some sheet and made an end cap and a small patch panel. I did not have to make a back to the cap as I will tie this into the Inner rocker to complete the cap. This will give you an idea of where I'm going. After I coat the area with Rust Mort and neutralize the rust, I will weld in place.
Attach file:
(107.30 KB)
(101.97 KB)
(91.37 KB)
(85.77 KB)
(80.28 KB)
(84.95 KB)
This Post was from: https://packardinfo.com/xoops/html/modules/newbb/viewtopic.php?post_id=135584