Re: RIk's 56 ultramatic
Posted by R H On 2013/12/15 1:17:48
bronze cam bearings alum bronze
# 5 cam bearing going in first, tool my dad made, ft part has bearing in it
adapter goes into bushing, another on the opposite side to center the rod and bushing.
turn the nut and it goes on in, takes a little time, but better than beating them in, like shops do.
next up . putting cam in, then crank, then pistons.
Attach file:
(60.77 KB)
(84.29 KB)
(79.78 KB)
(47.37 KB)
# 5 cam bearing going in first, tool my dad made, ft part has bearing in it
adapter goes into bushing, another on the opposite side to center the rod and bushing.
turn the nut and it goes on in, takes a little time, but better than beating them in, like shops do.
next up . putting cam in, then crank, then pistons.
Attach file:
(60.77 KB)
(84.29 KB)
(79.78 KB)
(47.37 KB)
This Post was from: https://packardinfo.com/xoops/html/modules/newbb/viewtopic.php?post_id=136592