Re: HA's 52 200 Grey Ghost

Posted by Hans Ahlness On 2014/7/9 23:14:03

I'm looking at the rear axle seals, and trying to decide how the outer seal is removed from the carrier plate - the seal is staked in there, looks like I need to punch out the 3 crimps to remove the seal? I found a picture of the seal and gasket set on the MM website, although that may be a generic picture. That shows normal seals so I'd need to get the old one out of the carrier.

In this picture you can see one of the crimps that stake the seal in place, there are 3 total.

Am I on the right track?

Attach file:

---

  (39.56 KB)