Re: 1940 120 Convertible Coupe Restoration
Posted by John On 2015/1/12 8:27:12
We took the body off so the owner could change the transmission out to an original overdrive trans. He also took the center section out of the axle and had a new crush sleeve installed.
Once the body was back on I braced the right rear body mount to keep it from collapsing. I leveled the body on the frame so I'd have a good starting point to start setting up floor braces at the right height. I'll get the floor braces blasted, then weld in the reinforcements and start welding in the new metal.
Attach file:
(78.22 KB)
Once the body was back on I braced the right rear body mount to keep it from collapsing. I leveled the body on the frame so I'd have a good starting point to start setting up floor braces at the right height. I'll get the floor braces blasted, then weld in the reinforcements and start welding in the new metal.
Attach file:
(78.22 KB)
This Post was from: https://packardinfo.com/xoops/html/modules/newbb/viewtopic.php?post_id=155942