Re: Stewart's 1955 Packard 400
Posted by Stewart Ballard On 2015/3/30 19:37:31
Thanks again TroyT... I think.
I never would have guessed it went there.
I messed with it tonight out in the shop and still can't picture it. Place round peg in square hole I guess. I'll wait until I order the replacement rubber pieces.
Just sand blasted parts tonight.
In other shop news, I decided in February that I needed to better insulate my shop before next winter. So I found a building supply discounter on Criagslist and drove up to Bloomington,IN last Friday to pick up 40 sheets of insulation board. My goal it to put up one sheet a day. Will figure out a ceiling later in the summer.
Attach file:
(147.62 KB)
(109.27 KB)
I never would have guessed it went there.
I messed with it tonight out in the shop and still can't picture it. Place round peg in square hole I guess. I'll wait until I order the replacement rubber pieces.
Just sand blasted parts tonight.
In other shop news, I decided in February that I needed to better insulate my shop before next winter. So I found a building supply discounter on Criagslist and drove up to Bloomington,IN last Friday to pick up 40 sheets of insulation board. My goal it to put up one sheet a day. Will figure out a ceiling later in the summer.
Attach file:
(147.62 KB)
(109.27 KB)
This Post was from: https://packardinfo.com/xoops/html/modules/newbb/viewtopic.php?post_id=159723