Checking the fit of the right rear pan. It's not in there straight since the outer rear edge needs to be turned down into a flange to fit against the fenderwell. Once that's done it'll slide all the way back into place. I'm 90% finished with the left pan so I can start welding the inner/outer rockers, quarter, and front lower cowl panels in place. The inner/outer rockers sandwich the floor pans so I needed to have all of the pans done before anything else could be welded in for good.
Attach file:
(41.56 KB)
(46.70 KB)
(48.43 KB)
This Post was from: https://packardinfo.com/xoops/html/modules/newbb/viewtopic.php?post_id=163141