Re: 1940 120 Convertible Coupe Restoration

Posted by John On 2015/7/13 15:07:49
With the floor pans mostly roughed in I turned back to the section under the back seat. I had the center section made but needed to make the side pieces. The left side is fabbed and welded in, just started on the right side last week. I bent the back edges of the floor pans to fit against the rear seat floor section. Also trimmed the rear seat pan to fit up nicely once it's ready to weld in, and drilled holes for the plug welds.

Attach file:


jpg  (36.12 KB)
69886_55a41a43b9f6e.jpg 800X600 px

This Post was from: https://packardinfo.com/xoops/html/modules/newbb/viewtopic.php?post_id=164181