ft hub bearing
that hub, is the only part in trans that is Rockwell hard,,
converter shaft with inner rings....used 2 ,,but machine shop, didn't sq end next to flange, these mods, one needs to do themselves, if I had a grinder for lathe, and surface grinder I would have,,,
I just wanted to make sure ft seal had a flat area..but I will see,,,
all bushings are aluminum bronze ,, only used 2 Packard bushing, ft pump bushing, and the reactor bushing, with the deep grooves,, started to make it,, was a pain......trying to groove it.....
bushing are rear pump, planetary,, high range clutch..
could of put the outside rear pump bushing on needle, but to hard to find a fit........
bottom, line,,,, someone with play money needs to step up and get parts made....redesign parts ..to use needle/ roller bearings.,,i did what I could, on my ,,little income,,
of coarse,, the proof in the working trans, I am getting to that, I would but this trans on a trans dyno if there was an adapter....also could have a spare engine, to hook up to,
Attach file:
(46.33 KB) (39.46 KB) (39.32 KB) (39.58 KB) (51.95 KB)
This Post was from: https://packardinfo.com/xoops/html/modules/newbb/viewtopic.php?post_id=167558