Re: 1940 120 Convertible Coupe Restoration

Posted by John On 2015/10/8 14:39:01
I have nearly the whole left side welded in; everything except one rear body mount brace against the inner fenderwell, the outer quarter panel, and lower front cowl panel. Lots of final fitting/trimming/reshaping to get it all fit together well. This is where good patterns would have helped a lot, but the original parts were in such rough shape it was impossible to make 100% correct patterns. There were 308 plug welds so far. Next step is to fit the outer quarter and cowl panel, then lead all the door jamb seams.

Attach file:


jpg  (56.18 KB)
69886_5616c62743ac0.jpg 800X600 px

jpg  (38.81 KB)
69886_5616c631477c9.jpg 800X600 px

jpg  (38.42 KB)
69886_5616c63c3de0d.jpg 800X600 px

jpg  (41.14 KB)
69886_5616c64765cd3.jpg 800X600 px

jpg  (45.31 KB)
69886_5616c65079024.jpg 800X600 px

This Post was from: https://packardinfo.com/xoops/html/modules/newbb/viewtopic.php?post_id=167702