Re: Stewart's 1955 Packard 400
Posted by Stewart Ballard On 2016/5/14 11:25:24
I picked up the water inlet from NAPA this morning. It's cast aluminum and about 1.5" taller then the original. The bolt holes are a very close match but not close enough to bolt right on. Also the bolt holes are two small.
Hopefully I can drill out the holes to make then larger and that, in turn, will align them better with the original. I think it will be usable unless someone gives me a reason why that extra height is going to effect something else later on.
I'll keep you posted.
Attach file:
(185.18 KB)
(120.96 KB)
(166.04 KB)
(194.04 KB)
Hopefully I can drill out the holes to make then larger and that, in turn, will align them better with the original. I think it will be usable unless someone gives me a reason why that extra height is going to effect something else later on.
I'll keep you posted.
Attach file:
(185.18 KB)
(120.96 KB)
(166.04 KB)
(194.04 KB)
This Post was from: https://packardinfo.com/xoops/html/modules/newbb/viewtopic.php?post_id=176769