Re: Henry's 37 Limousine

Posted by Cli55er On 2017/2/2 16:21:55
Howard,

You are right, i went back and looked at the packets that came with bottles of Evans. you can put stop leak in it.

if it doesn't stop on its own, i may try a small dab of this.https://barsleaks.com/product/powder-radiator-stop-leak-conditioner/

i'm not ready to go there yet. i'm a bit concerned it will muck up the Gano filter. the bar's leak says it will fit through a 24 gauge mesh....i'm pretty sure the Gano is larger then that. 24 is pretty dang small...small enough you wouldn't feel it if i pocked you with a 24 Gauge needle (healthcare related)

the seeping seemed to slow some. i heat cycled again last night. and tightened bolts again.

here is a pic of the seeping. you can see the cresent moon shape of the fluid sitting in the groove at the bottom of the freeze plug. yellowish color. takes about 2 days and it will finally run down the side of the block. very slow, which is why i'm hoping it fixes itself.

Attach file:



jpg  (30.25 KB)
491_5893a2f361431.jpg 640X480 px

This Post was from: https://packardinfo.com/xoops/html/modules/newbb/viewtopic.php?post_id=187573