Just a side project, but I took the A/C tube rubber rings that hold the clear rear deck vents and drew them up in SketchUp which is a free 3D modeling software.
Once done, I uploaded them to ShapeWays
SharpWays to have them 3D printed in a strong/flexible black plastic, since rubber, silicone, or urethane was not an option. They also have other materials you can have things made in as well.
I didn't model the mounting holes, as I figure they then could be drilled to fit the application later.
I'll report back later to see if it was a successful endeavor, as I hope to use them to replace the petrified/cracker rubber ones that I have.
Attach file:
(64.51 KB)
This Post was from: https://packardinfo.com/xoops/html/modules/newbb/viewtopic.php?post_id=187915