Here are some photos to follow Fred's post above. The engine, trans and drive shaft are set in place. The front half of the body is being seam sealed where the new floor pans were installed and por15 will be applied.
<a href="http://s671.photobucket.com/user/JamesRFrom/media/Packard%20400/KIMG0364.jpg.html" target="_blank"><img src="http://i671.photobucket.com/albums/vv72/JamesRFrom/Packard%20400/KIMG0364.jpg" border="0" alt=" photo KIMG0364.jpg"/></a>
<a href="http://s671.photobucket.com/user/JamesRFrom/media/Packard%20400/KIMG0366.jpg.html" target="_blank"><img src="http://i671.photobucket.com/albums/vv72/JamesRFrom/Packard%20400/KIMG0366.jpg" border="0" alt=" photo KIMG0366.jpg"/></a>
<a href="http://s671.photobucket.com/user/JamesRFrom/media/Packard%20400/KIMG0362.jpg.html" target="_blank"><img src="http://i671.photobucket.com/albums/vv72/JamesRFrom/Packard%20400/KIMG0362.jpg" border="0" alt=" photo KIMG0362.jpg"/></a>
This Post was from: https://packardinfo.com/xoops/html/modules/newbb/viewtopic.php?post_id=188561