Re: Henry's 55 Constellation

Posted by HH56 On 2009/2/16 16:53:03

You've got incredibly good eyes, that's all I can say!!

If you are talking the wall thickness & position of the large circumference, average measurement of the 3 NOS I have is .297 on the thin side and the thick side is .311.

Am not sure that is not more of a measure of mfg mold being off center than design because there is not word one in manual, SAE development description, or any document I have re orientation. If it were a design or an issue, am sure something would be mentioned. I suppose I would put the thicker part up because the bars are always pulling the arm with down force against the rubber.

Anybody else's opinion more than welcome & if it is a design would sure like a reference.