Re: PackardDon's 1956 Clipper Custom Sedan

Posted by Packard Don On 2020/7/2 22:38:42

The last time I was at my shop was in March where I took the Clipper outside while a lift was being installed. After getting it off the stands that it was on for the last 12 years, I found that the tail was nearly dragging and the TorsionLevel Ride wouldn't work. However, after putting it back into the shop, it seemed perfectly level and now, after moving it over using wheel dollies, the rear is quite high! I wonder how it is doing than when there isn't even a battery in it.

Not the best of photos and it's still on the dollies but the rear is clearly up.

Attach file:

---

  (292.08 KB)