Re: PackardDon
Posted by HH56 On 2022/5/25 8:57:14
Maybe a Monday or Friday car where whomever did the cutting was wanting to be somewhere else. Factory recommendation as shown in these two photos has the hole much smaller and neater. That one doesn't look like the supplied rubber finish grommet will even cover the excess area of the opening.
Are you going to be able to remove the spot welds and neatly keep the blower flange in a decent enough condition for the factory look upon reinstallation?
Attach file:
pass side.jpg (177.21 KB) engine side.jpg (168.29 KB)
This Post was from: https://packardinfo.com/xoops/html/modules/newbb/viewtopic.php?post_id=244239