Re: Stewart

Posted by HH56 On 2023/6/12 18:50:36

I believe there is a photo of the two switches side by side in that procedure I posted. What I did to measure for length was assemble everything including the modified nut just like it would be in the car and lay them in position as if they were mounted then cut the GM shaft to match and also marked where the notch or slot for the retaining clip would need to be cut.

Because the knob is heavy, on the triangular GM shaft I had to use a spacer to fill the excess hole space in the knob so it would not wobble. If you wanted to solder or maybe use JB Weld to make a more permanent fix that might work better than the loose shim stock I used.