Re: BigKev
Posted by BigKev On 2023/6/21 14:07:25
Here is another view of the woodwork. This should be pretty dead on the original layout and size.
Missing would have been a plywood panel attached to the two front diagonal supports behind the seat.
Since I have a split front seat and want to maintain access to the rumble seat foot well as a second trunk, I will have plywood on the sides (between the supports and the sides of the body). The middle portion will remain open.
All of the boards along the bottom support the side cardboard panels that finish off the rumble seat area. These boards were just nailed in, as there is evidence of the small nails used along all the existing wood, as well as small pieces of the original black cardboard-like panels.
All this wood was cut out of that large piece of Ash I purchased a while to make those folding B-Pillar posts.
I need to remove the fire extinguisher that was last filled/inspected in 2007, as that area will be enclosed and inaccessible.
Attach file:
20230621_080851.jpg (122.98 KB)
Missing would have been a plywood panel attached to the two front diagonal supports behind the seat.
Since I have a split front seat and want to maintain access to the rumble seat foot well as a second trunk, I will have plywood on the sides (between the supports and the sides of the body). The middle portion will remain open.
All of the boards along the bottom support the side cardboard panels that finish off the rumble seat area. These boards were just nailed in, as there is evidence of the small nails used along all the existing wood, as well as small pieces of the original black cardboard-like panels.
All this wood was cut out of that large piece of Ash I purchased a while to make those folding B-Pillar posts.
I need to remove the fire extinguisher that was last filled/inspected in 2007, as that area will be enclosed and inaccessible.
Attach file:
20230621_080851.jpg (122.98 KB)
This Post was from: https://packardinfo.com/xoops/html/modules/newbb/viewtopic.php?post_id=258365