BigKev wrote:
Quote:

TxGoat wrote:
Mine has a single bolt attaching the brace to the bottom of the frame immediately ahead of the radius rod ball socket. The brace is a straight, light sheet metal channel with flattened ends. The flanges go down. The fender has a flat lower flange behind the wheel opening about 3/4" wide, and about 5" back of the wheel opening, it widens to about 1" for about 2". The outboard end of the brace attaches there with two small bolts.

The installed brace makes a 90 deg angle to the lower edge of the fender, or close to it. If you have a stock brace, attaching it to the frame would show you about where should attach to the fender.

How far are the two bolt holes in the fender flange from the outside edge of the fender?