Re: BigKev's 1937 115-C Convertible Coupe

Posted by TxGoat On 2024/1/19 16:12:51

Forgot about that...!

The 2 bolt holes in the lower fender flange are 5/8 inboard from the vertical side of the fender. They are 3/4" apart, and they accommodate 1/8" bolts, nuts & washers.The distance from the center of the brace frame bolt to the center line of the fender bolt holes is 19 3/4". The lower edge of the fender has a very slight inward curve going forward from the running board to the wheel opening, and the vertical side of the fender also has a slight inboard curve. Going forward from where the fender mates to the running board to a point half way between the two brace holes in the fender flange is 23 1/2". These are steel tape measurements, but they should be within 1/16". Both fenders on my car show the same slight inboard curve ahead of the running board.