Re: 1937 120 Conv. Sedan - Blanche

Posted by TxGoat On 2024/4/8 8:43:25

My car is assembled exactly like the pictures in # 184 and 185 above. Notice the the way the rear sway bar is mounted. It is not symmetrical, and it needs to be installed the way the pic in # 184 shows it.
The header pipe goes under the frame near the front running board bracket, then through the frame behind the big muffler.

When you re-install the rear sway bar, it needs to touch the shock arms on both sides at all 4 bolting points before the bolts are tightened. If it doesn't, place washers in the gaps to fill them before tightening the bolts. When the car is sitting on a level surface, tightening the sway bar bolts should not pull on the shock arms. The procedure is described either in the shop books or in one of the service bulletins.