Re: Stewart's 1955 Packard 400
Posted by Stewart Ballard On 2024/6/18 20:34:05
I trimmed off the ends of those trim clips and installed the door stainless trim and the handles this week. I hope it is all good because that long piece that locked the door handles on is not coming back out again. Not in one piece anyway.
After 10 years of collecting dust I pulled the rear bumper out of storage and put it on some saw horses today. It is rough but it will have to do for now. There is no way I can budget for that kind of repair at this time. The worst parts appear to be on the bottom so hoping the upper parts polish up enough that only a few people notice the underside.
Attach file:
20240617_144630_resized.jpg (398.87 KB)
20240618_144927_resized.jpg (826.72 KB)
20240618_145257_resized.jpg (657.15 KB)
20240618_150319_resized.jpg (546.33 KB)
20240618_144931_resized.jpg (712.88 KB)
After 10 years of collecting dust I pulled the rear bumper out of storage and put it on some saw horses today. It is rough but it will have to do for now. There is no way I can budget for that kind of repair at this time. The worst parts appear to be on the bottom so hoping the upper parts polish up enough that only a few people notice the underside.
Attach file:
20240617_144630_resized.jpg (398.87 KB)
20240618_144927_resized.jpg (826.72 KB)
20240618_145257_resized.jpg (657.15 KB)
20240618_150319_resized.jpg (546.33 KB)
20240618_144931_resized.jpg (712.88 KB)
This Post was from: https://packardinfo.com/xoops/html/modules/newbb/viewtopic.php?post_id=273040