Re: Keegan's 55 Clipper Deluxe
Posted by Keegan Chaput On 2010/2/18 0:03:08
Been slowly chipping away where time permits. Hopefully I'll be able to fill the big holes soon and move onto the Oh-so-many little holes.
Got the big piece test fitted with the help of some sheet metal screws. It needed some extra help to fit, but it wasn't too bad.
It takes a while, but eventually you get all the spot welds connected to make a solid repair.
I've started the toe board repair as well. I'll finish weld it all when I've got all the patches in. Hopefully the drivers side floor will be done before next Monday.
It will look much better after some time with the grinder and some seam sealer to smooth the rough edges.
Attach file:
(106.18 KB)
(85.62 KB)
(77.96 KB)
(102.36 KB)
Got the big piece test fitted with the help of some sheet metal screws. It needed some extra help to fit, but it wasn't too bad.
It takes a while, but eventually you get all the spot welds connected to make a solid repair.
I've started the toe board repair as well. I'll finish weld it all when I've got all the patches in. Hopefully the drivers side floor will be done before next Monday.
It will look much better after some time with the grinder and some seam sealer to smooth the rough edges.
Attach file:
(106.18 KB)
(85.62 KB)
(77.96 KB)
(102.36 KB)
This Post was from: https://packardinfo.com/xoops/html/modules/newbb/viewtopic.php?post_id=47584