Re: Keegan's 55 Clipper Deluxe
Posted by Keegan Chaput On 2010/2/27 18:40:28
Rocker Panel #2
Just a repeat of the drivers side.
I still need to trim the excess sheet metal from the bottom. That's where the inner panel extends below the outer panel.
I'll be going back to grind down the welds later. It's a nice activity for when you want to let the mind wander.
I also patched a hole in the floor that I didn't take a picture of. It was right where the rear seat locating tab was located on the drivers side. I'll have to remember to put that tab back.
Attach file:
(103.41 KB)
(94.35 KB)
(90.78 KB)
Just a repeat of the drivers side.
I still need to trim the excess sheet metal from the bottom. That's where the inner panel extends below the outer panel.
I'll be going back to grind down the welds later. It's a nice activity for when you want to let the mind wander.
I also patched a hole in the floor that I didn't take a picture of. It was right where the rear seat locating tab was located on the drivers side. I'll have to remember to put that tab back.
Attach file:
(103.41 KB)
(94.35 KB)
(90.78 KB)
This Post was from: https://packardinfo.com/xoops/html/modules/newbb/viewtopic.php?post_id=48234