Re: Peterson's 1940 Packard
Posted by West Peterson On 2010/3/5 15:29:13
Thoroughly clean the bearings in solvent and then blow dry with compressed air. NEVER spin the beariings with compressed air, doing so runs the risk of nicking the rollers.
27. To pack them, put a wad of appropriate high-temp axle grease in the palm of your clean hand and push the bearing through it several times, as shown. Work the grease through the bearing rollers, and continue until it oozes out the other side.
28. Drop the inner bearing back into place, narrow end of taper first.
Attach file:
(77.20 KB)
(83.71 KB)
27. To pack them, put a wad of appropriate high-temp axle grease in the palm of your clean hand and push the bearing through it several times, as shown. Work the grease through the bearing rollers, and continue until it oozes out the other side.
28. Drop the inner bearing back into place, narrow end of taper first.
Attach file:
(77.20 KB)
(83.71 KB)
This Post was from: https://packardinfo.com/xoops/html/modules/newbb/viewtopic.php?post_id=48687