more putting the torque converter back together. i used a blind hole puller to get those small bushings out. it worked great and autozone lets you rent it and you get your money back when you bring it back. i tried to show the sizes of the bushing installers that i used. everything went together very easy and very well, so enjoy the show.....but if you can find the show stopper....you get a cookie. man, i just can't catch a break!
Portlandon....if you see the problem...may i ask for your assistance on this piece, if it is still available?
oh and guys, in the very last picture....what do those O-rings go too. i have rebuilt the transmission complete to my knowledge and now the torque converter is almost done and i cannot tell where those o-rings go. they are in the baggy that has the paper seal for the top of the torque converter shaft. so i am very confused.
thanks,
Hank
Attach file:
(100.82 KB)
(106.13 KB)
(94.22 KB)
(102.99 KB)
(88.13 KB)
(122.63 KB)
(119.28 KB)
(129.42 KB)
(133.18 KB)
(145.22 KB)
(102.17 KB)
(107.33 KB)
(117.65 KB)
(113.96 KB)
(122.50 KB)
(98.27 KB)
(128.08 KB)
(92.91 KB)
(135.71 KB)
(119.02 KB)
(124.40 KB)
(125.36 KB)
(125.96 KB)
(148.47 KB)
(124.79 KB)
(134.46 KB)
(112.80 KB)
(90.64 KB)
(118.81 KB)
(81.08 KB)
(93.44 KB)
(96.65 KB)
(136.37 KB)
(117.97 KB)
(116.39 KB)
(95.86 KB)
(136.62 KB)
(130.27 KB)
(112.39 KB)
(115.08 KB)
(127.90 KB)
(119.87 KB)
(112.35 KB)
(106.05 KB)
This Post was from: https://packardinfo.com/xoops/html/modules/newbb/viewtopic.php?post_id=58432