Re: Henry's 55 Constellation

Posted by Cli55er On 2010/9/5 18:54:47

i am going to take it back apart and show you guys what i did.

the reactor shaft will spine freely without the pump half on, but the shaft that goes into the reactor is locked in both direction, you should beable to turn it one way and it will lock the other.

the bushing in the end of the outside shaft fits good, but when i put the inside shaft through to mate the two halves, it is a PITA to get it one. shouldn't it be easy and you should beable to turn it when the two halves are mated.

if this doesn't work i'll just put the old bushing back in as i know it was fine with that one and it didn't seem to be in too bad of shape.

idk....i'm kinda lost and feel overwhelmed with it.

thanks for the info guys lets gets this figured out so i can put this trans work to rest. i'm ready

Hank