Well I finally got back in the garage this evening to get a little bit of work done. Taking that autobody class on Saturday's really cuts into my free time. But the class itself is pretty good. I MIG welded up all the holes in the hood of the project truck (emblem and hood ornament holes). Then I bumped out a few dents. Also a Uni-Spotter rocks! So it was good practice for some of the stuff I need to do on the Packard.
So on the Packard I bent up a new pump to carb fuel line, and also a new vacuum line between the carb and the distro. I also did a little website development work for a tool distribtion company in trade for a small oxy-acet. gas welding kit. I will use this to assist with the body work on the Packard. I am also going to try to source a MIG welder that I will use to put in the new floor pans.
Current pics of the new hardlines and the new torch:
Attach file:
(35.29 KB)
(34.01 KB)
(46.80 KB)
(61.18 KB)
This Post was from: https://packardinfo.com/xoops/html/modules/newbb/viewtopic.php?post_id=6328