Re: 51Packard's....51 Packard
Posted by Charles On 2010/12/14 22:34:29
12-14-10 continued...
After separating the face from the clock, I took the face apart. There is a "sleeve" around the slow/fast adjuster shaft that needs to be slid off (shown in pic below). Next the silver center trim piece must come off. It is held on with tabs on the back face of the clock. Once that is off, the clear piece comes off the back. I was surprised to see the numbers were on the clear piece instead of the back. I thought the clear piece would have just been a cover.
Now that it is apart and I get the oil out of it, how do you recommend I clean it up? I was thinking of just using some polishing compound. Any thoughts?
Attach file:
(61.22 KB)
(51.07 KB)
(53.61 KB)
(66.94 KB)
(66.36 KB)
After separating the face from the clock, I took the face apart. There is a "sleeve" around the slow/fast adjuster shaft that needs to be slid off (shown in pic below). Next the silver center trim piece must come off. It is held on with tabs on the back face of the clock. Once that is off, the clear piece comes off the back. I was surprised to see the numbers were on the clear piece instead of the back. I thought the clear piece would have just been a cover.
Now that it is apart and I get the oil out of it, how do you recommend I clean it up? I was thinking of just using some polishing compound. Any thoughts?
Attach file:
(61.22 KB)
(51.07 KB)
(53.61 KB)
(66.94 KB)
(66.36 KB)
This Post was from: https://packardinfo.com/xoops/html/modules/newbb/viewtopic.php?post_id=66635