Re: 51Packard's....51 Packard
Posted by HH56 On 2011/1/25 19:41:15
Here is what you'll find cutting or breaking the 3 screws off. They are 8-32 x 1/4 so no big deal replacing if they break other than getting broken part out of holes. Possibly try some heat or maybe get some vice grips on the screw head if there is enough there will convince them to move.
Looking at what's there it will have to come out and be cleaned and checked thoroughly. At least it doesn't look like a big deal to rewind--almost looks like something from science class. 2 windings wound in opposite directions probably --one atop the other.
When you take it apart, look out for a tiny ball bearing that lies in the bearing at end of armature. Otherwise just a spring and felt.
Electrically, the ground comes in and goes thru that bar with a contact on end which is probably a thermal circuit breaker, then to armature, out armature to the double wires going to one end of each coil and the other end of the coils back and soldered to the lead wires to switch.
Attach file:
(39.37 KB)
(46.52 KB)
(44.95 KB)
(43.92 KB)
Looking at what's there it will have to come out and be cleaned and checked thoroughly. At least it doesn't look like a big deal to rewind--almost looks like something from science class. 2 windings wound in opposite directions probably --one atop the other.
When you take it apart, look out for a tiny ball bearing that lies in the bearing at end of armature. Otherwise just a spring and felt.
Electrically, the ground comes in and goes thru that bar with a contact on end which is probably a thermal circuit breaker, then to armature, out armature to the double wires going to one end of each coil and the other end of the coils back and soldered to the lead wires to switch.
Attach file:
(39.37 KB) (46.52 KB)
(44.95 KB)
(43.92 KB)
This Post was from: https://packardinfo.com/xoops/html/modules/newbb/viewtopic.php?post_id=69466