Re: BigKev's 1954 Packard Clipper Deluxe Sedan

Posted by BigKev On 2008/4/19 15:43:36

Well I got most of the rear door dent out now. I still need to do a little smoothing as there is still a some lumpiness to it right across the middle line of the dent where the metal got stretched. But it basically up to correct level.

I went and bought a Stud Welder (uni-spotter) from Harbor Freight. It made it so much easier to pull those dents out where access to the back side of the panel is limited. If you have never used one, I highly recommend it. I have been using one in my auto-body class, and now I am spoiled by it.

I also have soaked the front drums in some Evapo-Rust. The are looking pretty good. I just need to take them and get them turned, and then I can put them in paint.

Hopefully I can get some pics posted soon, just had almost no time with all this business travel.