Re: 51Packard's....51 Packard
Posted by Charles On 2011/2/20 16:22:10
Here is the other part of the tests.
"With the meter still connected to the coil and brush terminal, check for a shorted armature winding by touching the probe to the steel in armature--both the shaft and the outer part. If good, then connect the other meter lead to the other brush and check continuity as the armature is rotated in the brushes."
Green dots are good connections. I also put one test probe on each brush and turned the armature and it showed a good connection for the complete revolution.
Attach file:
(57.35 KB)
"With the meter still connected to the coil and brush terminal, check for a shorted armature winding by touching the probe to the steel in armature--both the shaft and the outer part. If good, then connect the other meter lead to the other brush and check continuity as the armature is rotated in the brushes."
Green dots are good connections. I also put one test probe on each brush and turned the armature and it showed a good connection for the complete revolution.
Attach file:
(57.35 KB)
This Post was from: https://packardinfo.com/xoops/html/modules/newbb/viewtopic.php?post_id=71256