Re: 51Packard's....51 Packard

Posted by Charles On 2011/2/23 20:38:47

No reason to apologize HH56...your help has been invaluable. The results of the first test were good:

"Put a piece of paper between the brushes and armature or pull them away first. Now with the meter on ohms, and the probe connected at blue dot, you should not see any movement (infinity or open) anywhere except the two leads at the end of the harness cable. At the two wires, there should be 0-1 ohm or essentially a direct short."

Added the paper between the brushes. I did not get a "short" touching anything but the two wire leads and the bottom coil of wire (the one the brush it hooked up to anyway).