Re: 1940 Super 8 160 Model 1803 Project

Posted by Jim On 2011/5/22 22:06:21
Quote:

Joe Santana wrote:
No, that's fine, Jim. West also mentioned "about 3/4 inch" and the old looking spacers I have are exactly 3/4 in. So I will get some new shorter screws today (the incorrect motor was set back 1-1/4 inches) and install it. No pic necessary. Thanks for looking.


Joe, there is a little confusion here. That was West responding to your question in this thread. Sounds like you fellows have it figured out, though. If you need me to try to take a look under my dash, I can give it a try, but also have a radio, heater, and glove box all in the way.

This Post was from: https://packardinfo.com/xoops/html/modules/newbb/viewtopic.php?post_id=77375