Re: Henry's 55 Constellation
Posted by Cli55er On 2011/9/6 9:50:47
well i guess i'm just going to move on....and just assume that everyone uses the rope seal.
here just look at these pictures...those clips fell out of the screen.
looks like the drive pin for the vacuum portion sheered off at some point in its life. good thing i don't need this one. i'm just learning from it how it works and wuold like to salvage any parts i can from it to use later if i need to.
i took the staked pin out, but i can't seem to figure out how the shafts seperate. i know that the gear presses on, but i can't seem to seperate the long shaft at the joint where that pin is.
Hank
Attach file:
(62.88 KB)
(61.82 KB)
(68.98 KB)
(68.77 KB)
(50.60 KB)
(73.74 KB)
here just look at these pictures...those clips fell out of the screen.
looks like the drive pin for the vacuum portion sheered off at some point in its life. good thing i don't need this one. i'm just learning from it how it works and wuold like to salvage any parts i can from it to use later if i need to.
i took the staked pin out, but i can't seem to figure out how the shafts seperate. i know that the gear presses on, but i can't seem to seperate the long shaft at the joint where that pin is.
Hank
Attach file:
(62.88 KB)
(61.82 KB)
(68.98 KB)
(68.77 KB)
(50.60 KB)
(73.74 KB)
This Post was from: https://packardinfo.com/xoops/html/modules/newbb/viewtopic.php?post_id=85458