Re: Larry's 1951 Club Sedan Project
Posted by Larry51 On 2011/11/18 7:08:12
Some Shaping Tools I've Been Using . . . .
Here's a few of them, the basic ones. You can (and should) make your own or buy whatever is required as the more you have at hand the easier it will be to get the job done well and quickly.Add to these a wide selection of wet & Dry papers.
543 Selection of shaping tools including random orbital sander, 17-inch strip sander, 3M Super - and UltraFine foam-backed pads, 'cheese grater' and blades, 1/3rd sheet blocks etc (- each with a different grit paper in it)
551 Body File - used on metal highs
546 Home-made round paper holder up close.
547 Quick-change large block
Here's a few of them, the basic ones. You can (and should) make your own or buy whatever is required as the more you have at hand the easier it will be to get the job done well and quickly.Add to these a wide selection of wet & Dry papers.
543 Selection of shaping tools including random orbital sander, 17-inch strip sander, 3M Super - and UltraFine foam-backed pads, 'cheese grater' and blades, 1/3rd sheet blocks etc (- each with a different grit paper in it)
551 Body File - used on metal highs
546 Home-made round paper holder up close.
547 Quick-change large block
This Post was from: https://packardinfo.com/xoops/html/modules/newbb/viewtopic.php?post_id=89653