The throw-out bearing seems to be fine, still have to figure out where my pilot bearing went. As you can see, the pressure plate face has a little groove in it, probably be able to get it machined. The clutch disk appears to be in re-build able condition.
Next step is to get the flywheel off to be re-surfaced, and get my clutch re-built, if that is the cheaper alternative.
-Garrett
Attach file:
(33.14 KB)
(41.85 KB)
(27.62 KB)
(43.03 KB)
(36.61 KB)
(33.57 KB)
(27.07 KB)
(30.95 KB)
This Post was from: https://packardinfo.com/xoops/html/modules/newbb/viewtopic.php?post_id=109632