Re: GearRat's '52
Posted by Garrett Cuellar On 2012/10/25 18:35:43
Thanks Craig!
Sorry I didn't mention the condition my bearing was in. I have a big problem right now, the pressure plate is not fitting. All bolts but one are in place, the one hole is not lining up. It is a little bit off, it took a while to get the 5 I have in, in. Seemed as if it was too small, but now 5 bolts are in and the last hole is just barely out of reach. I really don't want to strip the threads. What do I do?!?!?!
Do I drill out the plate hole so it is a little larger?
Do I take it off and switch plates with the old one that I know fits?
I'm at a loss guys, nothing on this car has ever been an easy job.
-Garrett
Attach file:
(18.19 KB)
(18.79 KB)
(23.34 KB)
(27.76 KB)
(26.52 KB)
(32.16 KB)
Sorry I didn't mention the condition my bearing was in. I have a big problem right now, the pressure plate is not fitting. All bolts but one are in place, the one hole is not lining up. It is a little bit off, it took a while to get the 5 I have in, in. Seemed as if it was too small, but now 5 bolts are in and the last hole is just barely out of reach. I really don't want to strip the threads. What do I do?!?!?!
Do I drill out the plate hole so it is a little larger?
Do I take it off and switch plates with the old one that I know fits?
I'm at a loss guys, nothing on this car has ever been an easy job.
-Garrett
Attach file:
(18.19 KB)
(18.79 KB)
(23.34 KB)
(27.76 KB)
(26.52 KB)
(32.16 KB)
This Post was from: https://packardinfo.com/xoops/html/modules/newbb/viewtopic.php?post_id=111945