Here, is parts for needle bearing, inner rings, needle bearing, the needle bearing, no play on shaft, its a good fit. had to use two inner rings, so the thin one is where the seal will go. the shaft size now is 2-1/4 inch, 1/8 larger than org.. so i am using same front seal just 2-1/4 bore.
will put up other pictures later.
ps, that one piece is what i use to press on inner rings. have pictures of that to.
Attach file:
(142.96 KB)
(163.53 KB)
(107.46 KB)
(135.10 KB)
This Post was from: https://packardinfo.com/xoops/html/modules/newbb/viewtopic.php?post_id=111394