Re: RIk's 56 ultramatic

Posted by R H On 2016/4/28 12:20:35

that's what I thought had to be done, the frt engine mounts, but I didn't want to deal with that,

cause I tried to move trans, and it didn't want to go, and also the rear flange with that off it could go higher, and over more,

I was also thinking, access from inside, 1960 Studebaker had an access panel to get to top trans bolts, but that's not the problem,,

thanks for replies,, glad I didn't have to remove motor, I think my problem was , dirty sector, and pinched wires pb side,

where can you get that type of wire, everything now days use plastic insulation ,,,and it's stiff,