Re: RIk's 56 ultramatic
Posted by R H On 2016/5/17 21:44:17
exhaust
had to make the cradle, the rubber, after market hanger, cut it, driver side had to punch another hole,
driver side res pipe is pretty close to gas tank, might have to wrap it,
still need to finish adjusting and tightening , pass side header pipe is about an inch to long. but not taking back off for awhile. its just not centered in frame
Attach file:
(61.44 KB)
(74.66 KB)
had to make the cradle, the rubber, after market hanger, cut it, driver side had to punch another hole,
driver side res pipe is pretty close to gas tank, might have to wrap it,
still need to finish adjusting and tightening , pass side header pipe is about an inch to long. but not taking back off for awhile. its just not centered in frame
Attach file:
(61.44 KB)
(74.66 KB)
This Post was from: https://packardinfo.com/xoops/html/modules/newbb/viewtopic.php?post_id=176917