Re: RIk's 56 ultramatic

Posted by R H On 2017/3/26 18:02:43

Things look good. Converter is dry..bell housing some oil...so it must of dripped instead of flinging..

Plan is to enlarge oil holes on convert. Shaft.

And add hole at end of shaft as packard did.

Will be removing other parts..going to add extra plate in high range clutch..

Not sure if i am going to put a New needle bearing and inner ring..

New seal for sure and maybe some type of to help seal..dry seal..

That's around 2000 miles. Maybe more..

Not sure about shift motor..works now. By putting in new shift relay..

I did put a ground jumper lead on parking relay..put that was after the motor was working.. Tabs broke off. And just used super glue to hold it. Plate up.. I may solder case to ground. Lug.

Attach file:

---

  (204.04 KB)


  (203.00 KB)


  (319.15 KB)


  (175.67 KB)


  (259.52 KB)