Re: RIk's 56 ultramatic

Posted by R H On 2017/12/7 11:13:57

Ugh..

After trans install.. Shift motor went to park..

Went to take out of park..to tighten drive shaft nuts.

Pushed P...didn't go into park.

After going thru tests..didn't have power with l.h.d.

Went under touched motor went into R. So dropped pan..for some reason shift motor needed to be pulled out..so bent strap..everything works now..thinking about replacing motor strap with 1/16 or 1/8 inch flat hot roll.

Something must get grounded..but you can get cover off without moving trans over..I was thinking of putting insulation on on plate..when trans was out..