Re: RIk's 56 ultramatic

Posted by R H On 2017/12/25 2:16:53

Doing. TSI...noticed that there was not much. Room if any for oil return.

I was using .500..wide seal . going to use .300 wide seal.

Looking at a spare bell housing. Good size gap on stock bell housing.

So...I am thinking if adding a relif hole. Return.

I have needle bearing oil hole at pump in..so it's getting full pressure..so thinking of moving it 1/4 turn..90% . to slow it down

Then adding return suction relief hole. 180 %. From oil in hole.

Not sure on hole size..1/8 or 1/4 inch.

Attach file:

---

  (140.76 KB)


  (299.45 KB)