Re: RIk's 56 ultramatic

Posted by R H On 2018/2/8 23:27:55

Ok.

Owe. John. Dave...Ross. Your right...you can get shift motor off..with trans in..

Had to use a crow bar..could not find my little jack....found it after motor was off. And removed driver side exhaust pipe..

Windings look good.. But..the jumper wire came off when I pulled end cap back...cold..solder joint.

So..this time..doing it right..?..instead of soldering to a stub...going to do it like was done when made..

If these windings cooked..these can be rewound.

If the window motors. Are the same they can be done too...

These look like 16 ga..magnet wire..

I nicked one..so will get some varnish and brush it over it.. Magnet wire varnish..

And rethinking...my cable wire...it's flexible...but down the road it will get hard and crack..

Attach file:

---

  (249.31 KB)


  (218.81 KB)


  (170.75 KB)


  (183.53 KB)


  (151.54 KB)