Re: RIk's 56 ultramatic
Posted by R H On 2018/6/18 21:54:22
After much thought.
I believe Steve Williams comment about needle bearings...had to do with inside the 56 converter.
The driven hub. Is the only thing in that transmission that is Rockwell hard.. And a caged needle bearing. Used like I did.
The bell housing / converter shaft needle bearing. I do think the trans is more responsive.
And..the leak can be solved. But ..unless a dyno was available.. To test..taking that trans out gets old.
In the coming weeks going to replace the needle bearing with the bushing I made..
The leak is a pain..but not as much as waiting for oil to get to converter. And go into gear.. High idle few minutes.
Needs a needle bearing with 4. quarter inch holes..1. 1/8 inch hole does not cut it.
This Post was from: https://packardinfo.com/xoops/html/modules/newbb/viewtopic.php?post_id=203653