Re: RIk's 56 ultramatic
Posted by R H On 2019/12/16 3:21:27
This is what I'm planning for valve seal. Not a seal . but keep oil on guide from dripping on stem and getting sucked up.
Use silicone hose. Have hose past end of guide by inch or so. So it doesn't get hit when valve is lifted.
I could put a seal on stem. But inside hose might pull hose .
The hose is pushed all the way up. Guide.
5/8s id. vinyl. Hose fits tight on original guide.
.
Chevy valve seal. Think it's to going to be to tight on Packard valve stem.
Attach file:
(274.62 KB)
(254.85 KB)
Use silicone hose. Have hose past end of guide by inch or so. So it doesn't get hit when valve is lifted.
I could put a seal on stem. But inside hose might pull hose .
The hose is pushed all the way up. Guide.
5/8s id. vinyl. Hose fits tight on original guide.
.
Chevy valve seal. Think it's to going to be to tight on Packard valve stem.
Attach file:
(274.62 KB)
(254.85 KB)
This Post was from: https://packardinfo.com/xoops/html/modules/newbb/viewtopic.php?post_id=217639