Re: RIk's 56 ultramatic
Posted by R H On 2021/4/30 15:17:37
J.W.
That's a possibility.. I would be concerned about the switch popping out .someone turns key hard.
But I guess the tab could be made a bit dapper.
The top ear was bent out. I put it in a vise. It moved in but fell off.
If I do it again. I'm going to use a dowel inside bezel. To hold some brass shim stock. Solder to that.
There is some clearance on inside. With the glob on top I was able to get bezel in and out of dash.
I'm sure a weaker spring can be found
This Post was from: https://packardinfo.com/xoops/html/modules/newbb/viewtopic.php?post_id=233054